Microsoft Word - 476hernandez.docx CHEMICAL ENGINEERING TRANSACTIONS VOL. 43, 2015 A publication of The Italian Association of Chemical Engineering Online at www.aidic.it/cet Chief Editors: Sauro Pierucci, Jiří J. Klemeš Copyright © 2015, AIDIC Servizi S.r.l., ISBN 978-88-95608-34-1; ISSN 2283-9216 Hard Water Softening by Chronoamperometry Souheila. Ghizellaouia, Samira. Ghizellaoui*b, a Ecole Nationale Supérieure de Biotechnologie, Ali Mendjli BP.E66 25100, Constantine, ALGERIE. b Départment of Chemical, University Constantine1, Route de Ain El Bey 25000 ALGERIA. gsamira@yahoo.com Water distributed from the Hamma resource is supersaturated on carbonate of calcium, a not very soluble salt and a major component of tartar. During their circulation in the network, these waters give rise to scaling phenomenon which involves a significant economic problem because of the low thermal conductivity of the solid layer which reduces the output of the exchangers of heat. Moreover, the increase of the thickness of tartar reduces the water flow and causes the seizing of the valves and taps. The maintenance of the furred installations or the replacement of the drains is very expensive. For this reason, several chemical and electrochemical processes were applied for the evaluation and the inhibition of the furring capacity of the earthy waters of Hamma which feed the town of Constantine with drinking water. Electrocrystallization was executed on a steel electrode to study germination and growth of the calcium carbonate crystals. The method of accelerated scaling was also considered in the presence of lime, sodium carbonate and soda. The results indicated that water of Hamma is furring. The use of the method of accelerated scaling and the follow-up of electrocrystallization gave satisfactory results. 1. Introduction In the grounds of calcareous nature, the subsoil waters of Hamma become charged in significant concentrations of hydrogenocarbonate of calcium. For a content of 60French degrees, water is known as very hard and must undergo a treatment of softening or decarbonation before use, because they deposit significant quantities of calcium carbonate during their circulation in the network of distribution. Several methods of the evaluation of the furring capacity of a water were carried out these last years (Boulahlib-Bendaoud et Ghizellaoui, 2015, Chaussemier et al., 2015, Ghizellaoui et al., 2004, Ghizellaoui et al., 2005, Ghizellaoui et al., 2007, Ghizellaoui et Euvrard, 2008, Semineras et Ghizellaoui, 2015). In this Study, first of all, the electrocrystallization was executed on a steel electrode to study germination and growth of the calcium carbonate crystals. Then another electrochemical process (accelerated scaling) in the presence of lime, sodium carbonate and soda was considered for the evaluation and the inhibition of the furring capacity of waters of Hamma.. 2. Material and methods 2.1 Characteristics of the water from Hamma The physicochemical results of the analysis of Hamma water are recapitulated in Table 1. DOI: 10.3303/CET1543392 Please cite this article as: Ghizellaoui S., Ghizellaoui S., 2015, Hard water softening by chronoamperometry, Chemical Engineering Transactions, 43, 2347-2352 DOI: 10.3303/CET1543392 DOI: 10.3303/CET1543392 Please cite this article as: Ghizellaoui S., Ghizellaoui S., 2015, Hard water softening by chronoamperometry, Chemical Engineering Transactions, 43, 2347-2352 DOI: 10.3303/CET1543392 2347 By considering these results, we see that water of Hamma has a significant relative content of organic matter (TOC: 3.84 -7.5 mg/L). In addition, it is strongly mineral-bearing with a significant hardness (TH: 475-600 mg/L CaCO3). Therefore it is a primarily calcium bicarbonate (Ghizellaoui, 2008). Table 1. Hamma water analysis Temperature °C 31-33 pH 6.95-7.94 EC mS/cm 0.9-1.30 TOC mg/L 3.84- 7.50 CO2 mg/L 16.21-37.05 HCO3- mg/L 320- 432 Cl – mg/L 128-150 SO42 - mg/L 120-212 PO43 - mg/L 0.006-0.020 NO3 - mg/L 3.90-7,00 NO2 - mg/L 0- 0 NH4 + mg/L 0- 0 Total hardness mg/L CaCO3 475-600 Ca2+ mg/L 124-131 Mg2+ mg/L 30.48-43.20 Na+ mg/L 84-115 K+ mg/L 2.22-13 2.2 Tests of accelerated scaling This technique was developed by Lédion et al. 1985 (Fig. 1). Its principle consists in covering with CaCO3 a metal surface carried to a fixed negative potential of -1 V compared to an electrode of reference to calomel saturated with KCl. The application of this negative potential involves the reduction on the surface of metal primarily, of oxygen, according to the equation: O2 + 2 H2O + 4 e- → 4 OH- In the vicinity of this electrode, the presence of the ions hydroxides involves an increase in the pH locally and the hydrogenocarbonate ions can be transformed into ions carbonates according the reaction: HCO3- + OH- → CO32- + H2O The increase in the content of CO32- then involves the precipitation of calcium carbonate on the surface of the electrode according to the reaction: Ca2+ + CO32- → CaCO3 (Solid) Fig.1. utilisated Assembly 1. Potensiostat-galvanostat 2. Voltmeter to control potential. 3. Beaker of glass of 600 ml 4. Magnetic stirrer. 5. Bar magnet. 6. Electrode of reference to Calomel saturated with KCl. 7. Platinium Electrode. 8. Sample : pelletizes out of steel XC10 (diameter 11.3mm) drowned In an inert resin. 9. Plotting table . 10. Lid electrode holder + 1 7 8 6 5 4 3 AGITATEUR 2 10 9 -11 2348 3. Results 3.1. Qualitative results of electrocrytallization The first crystals obtained from the water of Hamma appear after 2 minutes of polarization. At the end of 60 minutes, there is growth of the latter without appearance of others. We observed a spontaneous nucleation followed by a crystals growth on all the surface of the electrode (Fig. 2). t=2min t=5min t=20min t=60min Fig.2. Germination and crystallization of water of Hamma 3.2. Curve of accelerated scaling for the water of Hamma The shape of the I=f(t) curve is given by (Fig. 3).The intensity decreases as the deposit covers metal surface gradually.The intersection of the tangent of inflection of the curve of accelerated scaling centered time corresponds to tE (time of conventional scaling). It is the time which represents the total covering of the electrode with CaCO3. The water is more furring as the time of scaling is short. Therefore, we noticed that tE for Hamma is of 3.7 minutes and its residual current is weak. What involves the formation of calcium carbonate a quite adherent precipitate. Fig.3. Curve of accelerated scaling for the water of Hamma. 3.3 Inhibition of scaling by sodium carbonate and lime 3.3.1 Use of the sodium carbonate Increasing concentrations of Na2CO3 were used (200-600 mg/L) at 30 °C.The study of the curve with 400 mg/L of Na2CO3 revealed an increase in the time of scaling until 15.4 minutes and a weak residual current (Fig. 4). What corresponds to the formation of a quite adherent precipitate scaling. Beyond 400 mg/L there is total inhibition of scaling. 2349 Fig.4. Curve of accelerated scaling for the water of Hamma added with 400 mg/L of Na2CO3. 3.3.2 Use of lime The lime (100-500 mg/L) was added to the water of Hamma. The effect of lime is more significant than the addition of Na2CO3. For the same concentration (400 mg/L), the time of scaling increased until to reach 27 minutes and form of chronoamperometric curve is modified (Fig. 5). Fig.5. Curve of accelerated scaling for the water of Hamma added with 400 mg/L of lime. 3.3.3 Use of soda The tests of accelerated scaling carried out on the water of Hamma at 30 °C for various soda concentrations (100-400 mg/L) showed that the time of scaling becomes significant as the soda concentration increases. The inhibiting effect marked is characterized by obtaining of a line for an addition of 400 mg/L of soda where the time of scaling is infinite (Fig. 6). 2350 Fig.6. Curve of accelerated scaling for the water of Hamma added with 400 mg/L of soda. 3.4 Evolution of the time of scaling and the residual current according to the addition of the lime, sodium carbonate and soda The study of the curves obtained, shows that the effect of the reagents (lime, sodium carbonate and soda) involves at the same time an increase in the time of scaling and an increase in the intensity of the residual current. These compounds which are adsorbed on the surface of the calcium carbonate particles which can be formed, may involve the precipitation of the calcium carbonate. It is noted that the time of scaling increases with the sodium carbonate concentration, lime and soda (Fig.7). One can consider, that starting from 500 mg/L of Na2CO3, 500 mg/L of Ca(OH)2 and 400 mg/L of NaOH, the time of scaling becomes practically infinite, the calcium carbonate stops to adhere to the electrode. Fig.7. Evolution of the time of scaling according to the concentration The measurement of the residual current is carried according to the concentration of (lime, sodium carbonate and soda) (Fig. 8). This residual current measures the speed to which dissolved oxygen is reduced to the electrode covered with the calcium carbonate deposit. The increase of the compactness and adherence of the deposit reduces the oxygen diffusion through this insulating film. What thus will involve a reduction in the residual current. 0 10 20 30 40 50 60 70 0 100 200 300 400 500 600 700 800 T im e o f sc a lin g ( m in ) Concentration (mg/L) Na2CO3 Ca(OH)2 NaOH 2351 Fig.8. Evolution of the residual current according to the concentration 4. Conclusion To characterize water of Hamma which feed the town of Constantine with drinking water, the chemical analysis which presents hardness of 60 °F reveals a furring character of the water. The compact and adherent deposits formed, crystallize in the form of calcite. The use of the electrocrystallization revealed also a spontaneous nucleation followed by a crystal growth. The tests of electrodeposition, carried out on furring water of Hamma, showed that CaCO3 overlaps steel at a very short time of scaling (tE=3.7 minutes). However after treatment, this time becomes high (> 3.7 minutes).The role of the chemical treatments (lime, sodium carbonate and soda) is clearly highlighted and it is possible to determine the adequate concentration of these reagents to soften the water of Hamma. The residual current for the whole of the curves of electrodeposition is weak and thus involves the formation of compact and adherent layers of sediment. References Boulahlib-Bendaoud Y, Ghizellaoui S. 2015. Effect of temperature on the efficiency of inorganic phosphate used as antiscaling inhibitors. J. Mater. Environ. Sci. 6 (2): 307-314 Chaussemier M, Pourmohtasham E, Gelus D, Pécoul N, Perrot H, Lédion J, Cheap-Charpentier H, Horner O. 2015. State of art of natural inhibitors of calcium carbonate scaling. Desalination 356: 47-55. Ghizellaoui S, Ledion J, Ghizellaoui S, Chibani A. 2004. Etude de l’inhibition du pouvoir entartrant des eaux du Hamma par précipitation contrôlée rapide et par un essai d’entartrage accéléré, Desalination 166: 315- 327. Ghizellaoui S, Chibani A, Ghizellaoui S. 2005. Use of nanofiltration for partial softening of very hard water, Desalination 179: 315-322. Ghizellaoui S, Euvrard M, Ledion J, Chibani A. 2007. Inhibition of scaling in the presence of copper and zinc by various chemical processes, Desalination 206: 185-197. Ghizellaoui S, Euvrard M. 2008. Assessing the effect of zinc on the crystallization of calcium carbonate, Desalination 220: 394-402. Ghizellaoui S. 2008. Evaluation and evolution of the quality of the water resources in the distribution network, Desalination 222: 502-512. Ledion J, Leroy P, Labbe J P. Juillet-Août 1985. Détermination du caractère incrustant d’une eau par un essai d’entartrage accéléré, TSM: 323-328. Semineras H, Ghizellaoui S. 2015. Use of chronoamperometry for the inhibition of scaling in hard waters. J. Mater. Environ. Sci. 6 (2): 377-382. -0.2 0.3 0.8 1.3 1.8 2.3 2.8 3.3 3.8 0 100 200 300 400 500 600 700 R e si d u l cu rr e n t (m A ) Concentration (mg/L) Na2CO3 Ca(OH)2 NaOH 2352